In the consumer packaging industry, sustainability and recycling stand as urgent imperatives amid escalating waste crises. This blog explores key statistics, challenges, innovations and prospects to guide brands toward responsible practices. Global plastic waste reached 225 million tonnes in 2025, with packaging comprising 33-40% of it, the largest source, whileRead More …
Category: Flexible Industry
Evolution of Printing Inks: From Conventional Solvents to Safer, High-Performance Formulations
Early printing inks relied on solvent-based systems for quick drying and strong adhesion but these prioritised performance over health and environmental concerns. Over decades, the industry shifted toward formulations balancing speed, safety and regulatory compliance amid rising VOC emission standards. Today, innovations in water-based, low-odour and sustainable inks drive thisRead More …
INK TEMPERATURE CONTROL ON GRAVURE AND FLEXO PRESSES
• Reduce top-up solvent consumption• Improve print quality• Lessen shop floor odour• Safer and healthier work area The conceptOn a rotogravure or a flexo press, let us assume that the ready-to-use ink temperature is 25°C and the viscosity is set to 19 (B4) cup seconds. As the printing progresses, theRead More …
Tips to get the best out of your DOCTOR BLADE
Check the blade holder for any damages and make sire holder is clean inside Set the blade straight in holder. Check so there is no waviness in blade. When bolts/screws are used for tightening from center and out crosswise. Use as low blade pressure as possible To achieve optimalRead More …
Swedev Guide Back-Up Blade
For optimal performance of your Swedev back-up blades, especially the 45° cut variants, ensure the top of the back-up blade does not extend to the cylinder’s end-point during doctor blade oscillation. It should stop approximately 10 mm short of the cylinder edge. This precaution prevents uneven wear and potential damage.Read More …